DIY Video Channel
Search Video
How to do it
Lagging jackets are available in 3 sizes. Ensure that you measure the height of your cylinder and choose between the 30” (750mm), 36” (900mm) or 42” (1050m).
Step 1
An insulating jacket pack normally consists of four plastic covered panels, two securing straps and a tie cord.
Step 2
Position the panels vertically around the cylinder, with the eyelets to the top. This allows any connecting pipework pass through the gap in the panels.
Step 3
Pass the supplied cord through the eyelets and tie off so that the panels fully cover the top of the cylinder.
Step 4
Use the two straps to secure the panels in the final position.
These panels insulate more effectively if they are not compressed, so do not over-tighten the straps.
Related Videos
How to Install a Water Butt
Woodie's DIY will show you how to install a water ...
How to Deal with an Airlock
Woodie's DIY will show you how to deal with an air...
How to Bleed a Radiator
Woodie's DIY will show you how to bleed your radia...
How to Insulate an Attic
Woodie's DIY will show you how to insulate your at...
How to Insulate Pipes
Woodie's DIY will show you how to insulate pipes. ...
Energy Saving Tips
It is so important these days to save energy, whic...